LCD3 e-Bike Display User Manual

LCD3 e-Bike Display User Manual

Dear customer, please read this manual before you use LCD3 instrument. The manual will guide you use the instrument correctly to achieve a variety of vehicle control and vehicle status displays.

Functions and Display

Instruments using the structure form of instrument body portion and the operation buttons are designed separately.electric push bike

Operation

1. ON/OFF

electric push bike

2. Display 1

electric push bike

2.1 Turn on backlight and headlights

electric push bike

2.2 Assist ratio gear (ASSIST) switch

electric push bike

2.3 6KM/H assist promotion function

electric push bike

2.4 Cruise function

electric push bike

2.5 Display and delete of single data

electric push bike

3. Display 2

electric push bike

In the riding mode after 5 seconds, display 2 automatically returns to display 1, and the original motor power (MOTOR W) display is replaced with motor operating temperature display (MOTOR ℃)display (the internal motor should be equipped with the temperature sensor and the output of temperature detection signal).
4. Display 3

electric push bike

In the riding condition, five seconds later, a single maximum speed (MXS) display automatically returns to the real riding speed (KM/H).

electric push bike

7. Automatically prompt interface

electric push bike

Electronic control system failure will display (flashing) fault code. Once the fault was removed, it automatically exits from the fault code display interface.
7.2 Motor temperature alarm
When the motor temperature (the internal motor should be equipped with the temperature sensor and the output of temperature detection signal) is over the warning value, MOTOR ℃ (℉) flashes to alarm at any display, meanwhile the motor controller will offer the appropriate protection to motor.

General Project Setting

1. Set maximum riding speed

electric push bike

2. Wheel diameter setting

electric push bike

electric push bike

3. Set the metric units

electric push bike

4. KM/H and Km stop flash after metric unit setting is completed. Hold button shortly again to
re-enter the maximum riding speed setting interface; or hold button long to exit from setting
environment of routine projects and save the setting values, returning to display 1.
5. Exit from routine project setting

electric push bike

Outline Drawings and Dimensions

electric push bike

Leave a Reply

Your email address will not be published. Required fields are marked *

Protected with IP Blacklist CloudIP Blacklist Cloud